Komatsu — ADAPTER WELDING INSTRUCTION - ELECTRODE WELDING

DISASSEMBLY AND ASSEMBLY ADAPTER WELDING INSTRUCTION • ELECTRODE WELDING 30-134 2. To prevent the introduction of weld-weakening impuri- ties, every weld pass should begin and end across a starter/runoff plate. Install these plates, made from scrap steel, as shown in the diagram. Do not stop or start a weld at the rear of the adapter leg! If rod length, adapter size, and welder position allow a continuous weld without stopping, use two starter/run- off plates near the lip leading edge. On large adapters and where stops for welder reposi- tioning are required, use two additional starter/runoff plates at the midpoint on both sides of the adapter.

These procedures also apply to the bottom leg of 11/2 - and 2-legs adapters. 3. If using four starter/runoff plates, weld the rear half of the adapter with alternating clockwise and counter clockwise passes. Build up the weld to a full fillet. If using only two starter/runoff plates, use the same technique, welding to the ends of the J-groove, then proceed to step 5. Do not weld to the lip leading edge! 4. If using four plates, continue welding to the ends of the J-groove. Do not weld to the lip leading edge! Alter- nate from side to side until the weld is complete. Main- tain a full fillet weld and tie weld ends together. 5.

Remove the starter/runoff plates, then smooth the for- ward edge of the welds with a conical grinder. Blend the welds concave to remove stress concentrations. 6. Turn the bucket over. 7. One-leg Flushmount Adapters fillet weld across the adapter equal to the lip leading edge thickness. Grind the ends smooth at weld junctions. If a lighter cavity extends forward of the lip leading edge, cover the opening with weld. Maintain a full fillet width over the entire weld.