Komatsu — ADAPTER WELDING INSTRUCTION - ELECTRODE WELDING

DISASSEMBLY AND ASSEMBLY ADAPTER WELDING INSTRUCTION • ELECTRODE WELDING Corner Adapter Modification and Installation Helilok adapters can be modified by cutting to fit bucket side plates. A bucket should never be cut to fit an adapter! The corner adapter should be positioned so that the point cuts clearance for the bucket. The best bucket wear protection is achieved when the adapter is posi- tioned so the nose is flush with an imaginary line ex- tending forward from the outside edge of the bucket side plate. If a clean trench is desired, corner adapters can be mounted so points are positioned flush with the out- side of the bucket.

When modifying an adapter, never remove more than 50% of the adapter top leg. The edges of the cuts should be chamfered 1/2"x 30o for weld prepara- tion. Follow welding procedures described in "Lip Adapter Installation". Install Helilok points according to the procedures de- scribed in ESCO Maintenance Catalog 100-1B (Rev.1), Helilok Tooth System Installation and Re- moval Instructions. 30-135