Komatsu — FIXED THROTTLE VALVE

STRUCTURE AND FUNCTION HYDRAULIC PUMP b. When load on actuator is large and pump discharge pressure is high When the load is large and pump discharge pressure PP is high, the force pushing spool (3) to the left becomes larger and spool (3) moves to the position shown in the diagram above. When this happens, as shown in the diagram above, part of the pressurized oil from port A passes through the LS valve, flows out from port C to port D , and the pressurized oil flowing from port C to the LS valve becomes approxi- mately 3/5 of main pump pressure PP .

When port E and port G of the LS valve are connected (see (1) LS valve), the pressure from port J enters the large diameter end of servo piston (9), and servo piston (9) stops. If main pump pressure PP increases further and spool (3) moves further to the left, main pump pressure PP flows to port C and acts to make the discharge amount the minimum. When piston (9) moves to the left, piston (7) is moved to the left. For this reason, springs (4) and (6) are compressed and push back spool (3). When spool (3) moves to the left, the opening of port C and port D becomes larger. As a result, the pressure at port C (= J ) drops, and piston (9) stops moving to the left.

The position in which piston (9) stops when this happens is fur- ther to the left than the position when pump pressure PP is low. 10-52