Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK FUEL LEVEL, ADD FUEL WARNING side of the fuel tank. the tank. 3. After adding fuel, tighten the cap securely. 3 - 77 When adding fuel, never l et the fuel overflow. This may cause a fire. If any fuel is spilled, wipe it up c ompletely. Never bring flames near fu el because it is highly flammable and dangerous. with fuel gauge (G), which is insta lled in the k. erations, add fuel through fuel fille r (F) to fill liters (132.1 US gal) REMARK If the breather hol e in the cap (1) becomes clogged, the pressure inside the t therefore clean the ank will go down and the fuel ma y not flow, breather hole from time to time.

To prevent air from being sucked into the engine, do not let the level in the fuel tank go down too low. CHECK WHEEL HUB N UTS, TIGHTEN Check for loose wheel hub nuts (1). If any are found, tigh ten them. Tightening torque: 152 0 to 1850 Nm to 189 kgm, 1121 to 1367 lbft) (155 Insert a socket wrench in a pipe, and apply a force of 17 40 N (177 kg) at a point 1 m from the fulcrum to give a tightening torque of 80 lbft). 1740 Nm (177 kgm, 12 When tightening the hu b nuts after replacing the tires, tr avel for 5 to 6 km, then check th e tightening torque to ensure that there are no loose bolts. If any stud bolt used to install the rim is broken, replace a ll the stud bolts for that wheel.