. OPERATION DETERMINING AND MAINTAINING TRAVEL ROAD 3 - 117 DETERMINING AND MAINTAINING T Determining and tra veling the road in the jobsite is an extre mely important factor both for reasons of s afety and for reducing the cycle ti me.To ensure safety in operations, do a DETERMINING TRAVEL ROAD el. As far as possibl e, restrict the travel road to one-way trav If it is impossible t o keep to one-way traffic, make the road with ample width to enable truck s traveling in opposite directions to pas s each other. If it is impossible to provide a sufficient road width, provide passing places at ng the road. e road so that the loaded truck passes on the side closest to the hill face.
s with poor visibility along the road, set up mirrors. various points alo Always design th e road so that the loaded truck passes o n the side closest to the hill face If there are curve s with poor visibility along the road, set In places where t he road shoulder is weak or likely to coll apse, set up a sign at a point at l east 1.5 m (4 ft 11 in) from the road sho ulder to warn of the danger. road to be traveled at night. 6°) as far as possible, and emergency escape points failure. It is important to s et up lighting or reflectors to enable the The grade of slo pe should be kept within 10% (approx.
should be set up on downhill slopes in case of any brake Make the road as straight as possible, and particularly in intermediate areas with curves, where the machine is traveling at high s peed, make the radius of the curve as l arge as possible. Small S curves ar e particularly dangerous, so avoid such curves. The radius of the curve must be a minimum of 12 to 15 m (39 ft 4 in to 49 ft 3 in). of curves as large as possible. the outside of curves. ds cross it. In particular, if roads cross at an angle on Make the radius Make the road wi der at curves than it is in straight areas. Make the outside of the curve slightly higher.
Be particularly ca reful to strengthen the road shoulder on As far as possibl e, design the road so that no other roa on slopes, a stepped difference is formed in the road. This is extremely dangerous, as it causes the ma chine to roll when traveling at high speed. e to provide a special road for the trucks. Cut the slope fac e to provide a special road for the trucks MAINTAINING TRAVEL ROAD Carry out the neces sary action according to the conditions t o insure that the road can always be travel ed in safety. Remove any une venness in the travel surface, sloping to the left or right, or drooping of the road sho ulder.
Make the road of ample strength and remove such obstacles a s rocks and tree stumps. otor grader. dust from rising and reducing the visibility. Maintain the road from time to time with a bulldozer or m Spray the road w ith water at suitable intervals to prevent dust from rising and reducing the visibility