Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing.Even in the areas where freezing is not an issue, the use of antifreeze COOLANT is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for two years or 4000 hours. As a basic rule, we do not recommend the use of any COOLANT other than SUPERCOOLANT (AF-NAC).

If you use another COOLANT, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of COOLANT, always keep the density of COOLANT between 30% and 68%. When selecting COOLANT, investigate the lowest temperature in the past and decide the density for the COOLANT from the COOLANT density table below. When actually deciding the density for the COOLANT, set it about 10 ° C (18 ° F) below lowest temperature. The density must be over 30% at least.

If the density of obtained COOLANT is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, please contact your Komatsu distributor. Coolant density table 4 - 28 Immedi ately after t he engine is stopp ed, the engine coolan t is hot and the pressure inside the radiator is high. Removing the cap an d draining th e water under this condition could cau se burns. Allow the engine to cool down , the n turn the cap slowly to relea se the press ure. Start th e engine and flush t he system.

When standing up or leaving the operator's seat, set the gear s hift l ever to the N position and set the parking brake switch to th e PARKING position. For det ails of starti ng the engine, see "OPERATIONS, CH ECKS BEFORE STARTING (PAGE 3-87)" and "STARTING ENGINE (PAGE 3-89)" in the OPERATION secti on of the Operation a nd Maintenanc e Manual When t he undercov er is removed, the re is danger of touch ing the fan. Never g o to the fron t of th e machine w hen the engine is ru Stop the machine o n level ground w hen cleaning or ch anging the coolant. Clean the inside of t he cooling syste m, change the coo lant accordin g to the t able below.

Interv Coolant al for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine E SUPERCOOLANT (AF-NAC) very two years or every 4000 hours whichever comes first Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64