Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR BELT TENSION, ADJUST CHECKING 4 - 48 Press the belt wi th your thumb with a force of approx. 98 N { at t he midpoint b etween drive pulley (1) and a lternator pulle Standard deflect ion (A): 13 -16 mm (0.5 - 0.6 ADJUSTING er mounting bolts (6) (2 places), and remo and nuts (1), (2) and (5), then turn nut (4) to 1. 2. 3. 4. 1. Remove cov er mounting bolts (6 cover. Loosen bolts the tension o After adjustin alternator (3) f the belt. g, tighten bolts and nuts (1), (2) and (5) to . Reinstall the the cover tou cover removed in s ches any moving p tep 1. Confirm that no art of the alternator.

REMARK Check each p ulley for breakage a nd wear of th e V-groov e. In particular, check that the V- belt does not touch the bottom of the V-groove. ality is found, ask your Komatsu distributor for replacement of the pulley. so lengthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnorm ality is found, ask y our Komatsu distributo If the V-belt is so lengthened that it cannot be adjusted a ny more or if it has any cuts or When adjusti ng the V-belt, do not press th e alternator di rectly with a bar, but put a wood piece, etc. in-between them.

If the V-belt h as been replaced wi th a new part, there will be initial elongation, so inspect a nd adjust it again after one-hour of o peration.