Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST ADJUSTING 1. Loosen bolt (1). initial elongation, so adjust the belt again after 4 - 49 CHECKING Press the mi ddle of the belt between the air conditioner compressor pu lley (1) and drive pulley (2) with the thumb (about is 10 mm (0.4 in), the belt tension is normal. bout 58.8 N {6 kg}). I f deflection (A) is 10 mm (0.4 in ), the be lt tension 2. Turn nut (2 ) to adjust so that t he belt deflects by approx. 10 mm (0.4 in) wh kg) at a poi pulley and en pressed with a finger f orce of ap prox. 58.8 N (6 nt midway betwe en the a ir conditio ner compressor drive pulley.

lt (1) and nut (2) to secure the compressor in 3. Tighten bo position. 4. Check eac h pulley for damag e, wear of the V-groove, and wear of the V-bel touching th t. In particular, be sure to check that the V-belt i s not e bottom of the V -groove 5. If the V-be lt is so lengthene d that i more or if it has any cuts or cracks, replace it. 6. If the V-bel t has been repla operating f or 2 to 3 days.