Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK FRAME WARNING CHECK BRAKING CAPACITY OF FOOT BRAKE WARNING 4 - 51 When carrying out inspe ction of the machine with the dump bod y raised , always set the dump lever to the HOLD position, lock with the dump lever lock knob, then use the body pivot 1. Wash the frame to make it easier to check. the frame for damage. k the colored portions in the diagram and i 2. Check all parts of the frame for damage. In particular, chec any cracks or dam contact your Ko procedure. k the colored portions age are found, repair the damage. Pleas matsu distributor for details of the repai detai If the machine moves, it will lead to serious injury.

If machine b egins to move during the inspection of braking capacity, lower the engine speed imm ediately, set shift lever at N po sition, an d then s et parking brake switch at P ARKING position. If inspection is carried out when the body pilot lamp is lighted up and th e shift indicator shows "F 1", there is danger that the internal parts of the tr Before carrying out in gear shift lever at the ansmission may be damaged. spection, lower the dump body securely and check that the body pilot lamp h as gone out, then place the "D" position and check that th e shift ind icator s hows " F2". Check the braking ca pacity of the foot brake as f ollows. 1. Stop the machine 2.

Set shift lever (2) speed, and check the engine speed 3. Lower the engine set parking brake abonormality is fo 1. Stop the machine on flat ground and depress s ervice br ake (1) to the D position, gradually raise the engin that the machine does not move even whe reaches 1550 rpm. speed, set shift lever at N position, a valve lever at PARKING position und, ask your Komatsu distributor fo nd the . If an r repair NOTICE If the dump body is not s eated and the parking brake is at "TRAV EL", the speed range is set to F1, eve n when the gear shift lever is at the "D" position.