Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 7. Fill the filter cartridge with clean fuel through the 8 small holes (B) in the new filter cartridge. 8. Coat the packing surface of the filter cartridge with oil. 4 - 57 When filling the filter ca rtridge with fuel, carr y out the filli cap Cap (A) fitted. (A) acts to prevent 9. Remove filter car tridge cap (A) and install to th 10. When installing, t ighten until the packing surfac e contacts the se al surface o f the filter holder, the n tighten it 3/4 of a turn. If the filter cartrid ge is tightened too far, the pa cking will be dam aged and th is will lead to leakage of fuel.

If the filter cartridge is t oo loose, fuel will also leak fr om the packing, s o always ti ghten the correct am When tighteni ng with a filter wrench, be extr emely careful no t to dent or 11. Check that the dr ain plug at the bottom of the water separator c up is tighte Tightening torqu e: 0.2 to 0.45 Nm ( 0.02 to 0.0 46 kgm, 0.1 to 0. 12. Open supply valv 13. When replacing t he fuel main filter cartridge (E VERY 1000 HO URS), repla ce the cartridge, then bleed the air. For details, see " main filter cartrid 14. Start the engine, check that there is no leakag e of fuel from the filter seal s urface or water separ ator mounting surface, then run for approx. 10 minutes at low