. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION OIL FILTER ELEMENT PUMP OUTLET PORT WARNING case the 4 - 58 The p arts a nd oil are at high t emperature after the e ngine is stopped , and may cause burns. Wait for the temperature to go down befor e starting the work. When removing the oil filler cap, turn it slowly to r elease the internal pressure, then remov 1. Set the container to catc h the oil under the filter case 2. 3. Remove oil, then Loosen drain plug (1) at tighten the plug hexagonal porti 4. Remove the element an d clean the inside o f the cas 5. Replace the filter gaske t and O-ring with n ew parts. Coat gasket a nd O-ring thinly with clean engine o il before i 6.
Assemble the new elem install it. Tightening torque for dr ain: 49 to 58.8 Nm (5 to 6 kgm, 36 .2 to 43.4 Tightening torque for ca se: 58.8 to 78.5 Nm (6 to 8 kgm, 43. 4 to 57.9 7. Run the engine for a sh ort time at idle, then stop the engine, and check that th e oil is up to the spec ified level. For details, see "CHEC K OIL LEVEL IN TR ANSMISSION CASE, ADD OIL (P AGE 3-74)". Run the engine at high id le, and when the oi l is warme d up, if th e Maintenance ca ution lamp flashes, r eplace the element immediately.