. MAINTENANCE SERVICE PROCEDURE CLEAN HYDRAULIC TANK STRAINER WARNING CHANGE OIL IN FINAL DRIVE CASE WARNING 4 - 75 The parts and oil a re at high temperature after th e engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If there is still pres sure remaining inside t he case, the oil o r plug may fly out. Turn the plug slowly to r elease the pressure, then remove it carefully 1. Lower the dum p body and stop the engine 2. Turn the cap pressure. 3. Remove plugs tank. Take the strain (1) of the 2 strainers at the front of the hydraulic er out from strainer case (2), then wash it in l. ner and plug (1) to strainer case (2).
of oil filler (F). 4. clean diesel fue 5. Install the strai ner and plug (1) to st rainer case (2 6. Tighten the cap of oil filler (F). The parts and oil a re at high temperature after th e engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If there is still pres sure remaining inside t he case, the oil o r plug may fly out. Turn the plug slowly to r elease the pressure, then remove it carefully . Refill capacity: L eft, right 13 liters (3. 43 US 1. Stop the machi ne so that casting lin e (1) is horizon tal and drain plug (P) is at th e bottom.
plug (P), drain the oil, then tighten the plug the hole for plug (G) to the specified level. 2. Remove drain again. 3. Add oil through the hole for plug (G ) to the specifi ed level 4. After adding oil , check that the oil is at the specifie d level. See "CHECK OIL (PAGE 4-43)". LEVEL IN FINAL DRIVE CASE, ADD OIL DRIVE