. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN STEERING, HOIST OIL TANK WARNING engine is stopped, and may cause burns. Wait for the GREASE EXTENDED GREASING INTERVAL DRIVE SHAFT (4 places) 4 - 79 EVERY 4000 HOUR Maintenance for every 2 50, 500, 1000 and 2000 ho urs service should be carried out at th temperature to go down before starting the work. When removing the oil fil ler cap, turn it slowly to releas e the intern Refill capacity: 129 lite 1. Lower the dump bod y and stop the engine. iller (F) to release the internal pressure cap. (1), then loosen drain plug (2) slowly to ourself, and drain the oil. amount of engine oil from oil filler (F). 2. 3.
Turn the cap of oil f before removing the Remove drain plug avoid getting oil on y ourself, and drain the oil. 4. Pour in the specified amount of engine oil from oil filler (F) 5. After adding oil, chec k that the oil is at the specif ied level. S ee CHECK OIL LEVEL IN STEERING AND HOIST OIL TANK, 4). ADD OIL (PAGE 3-7 (If equipped) Carry out greasing every 4000 hours or every two y ears (whichever 1. Using a grease pum p, pump in grease through the grease e arrows. fittings marked by th 2. Apply grease to the s pider portion until grease co mes out fr om the seal of the cap. off any old grease that was pushed out. 3. After greasing, wipe off any old grease that was pushed o