Komatsu — CONTENT OF DISPLAY (CONTROLLER, EXTERNAL DISPLAY LAMPS)

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) NOTICE the rated payload and 6 - 23 When stop ping the machine empty , stopping it during loading, or stopping it w hen loaded, always set to the gearshift l ever at the N position . (See "DISPLAY DURIN G NORMAL OPERATIONS (PAGE 6-21)".) If this is no t done, the time that the machine is stopped will not be calculated, a nd it will be included in the travel time w hen empty or the trav el time when loaded. As a result, the average travel speed will app ear to be lower and the data stored in th e payload meter will not be accurate.

In addi tion, the external display lamps will also st NOTICE In the follo wing cases (1) to (4), th e condition of the dump truck as seen by t he payload meter will be different from the actual condition of the dump truck. (1) When a new controller has been installed en replaced (2) When the controller has be See " (PAG OPERATION WHEN ERROR CODE F.CAL IS DISPLAYED OR CONTROLLER HAS BEEN RE PLACED E 6-63). the built-in battery has been replaced (3) When the built-in battery ha See " WHEN ERROR CODE F-09 IS DISPLAYED (PROCEDURE FOR REPLACING BATTERY) (PA GE 6-60).

(4) In add ition, if either of the fo llowing conditions should occur The e xternal display lamps give the estimate display although no loading is taking place. The di splay gives the time d isplay when loading even if more than 50% of the standard payload is lo aded and the m achine starts to travel. (The distance display is not given wh en traveling 0 to 160 m.) In the ca se of (1) or (4), carry out calibration with the machine empty dump the load.

The payload m eter will recognize the empty (stoppe Note that the cycle data record ed when dumping may be partially ina NOTICE After st arting dumping (operati ng the dump lever from FLOAT to RAISE), do not turn the power OFF within 5 sec onds after comple ting the dumping (opera ting the dump lever from LOWER to FLOAT ). Also, w ith operations other than dumping, do not turn the power OFF within 5 seconds after operating the dump lever to FLOAT from an y position other than FL OAT. If the st arting switch has been l eft at the ON position (power ON) for a lon g period without starting the engine, fir st turn the starting switch to the OFF posit ion, then start the engine.

If the en gine is started without t urning the starting switch first to the OFF p osition, the time that the starting switch was at the ON pos time. ition without starting the engine will also be calculated as part of th e "Stopped, Empty" time or the "Stopped , Loaded"