Komatsu — WHEN ERROR CODE F-09 IS DISPLAYED (PROCEDURE FOR REPLACING BATTERY)

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) PROCEDURE AFTER REPLACING BATTERY 6 - 62 Whe n the b attery is replaced, the backup power for the non-volatile memory insi de the payloa d meter is momentarily cut, so mistaken data (garbage) may enter the memo ry and caus e mistakes in the payload meter's r ecognition of he c onditio n of the machine. The followi ng operation is neces sary to remove this d 1. Turn th e starting switch to th e ON position. (F.CA L ma y flas 2. Using t he operator check m ode, set the machine ID, open ID , speed li mit, optio n code, date and time. 3. Without turning the starting switch to the OFF pos ition, start t he engin e.

( F.CA L may fl ash.) 4. Carry o 5. Load to near the rated paylo ad, then dump the lo 6. Move th e machine to a safe place, wait for at least 5 sec. after dumping the l oad i n Step 5 , then sto p the engine. 7. Turn th e starting switch to th e ON position again. Do not start the engine whe 8. Carry o ut the DATA ALL CL EAR in the operator c heck mode 9. Forcibly clear the data for th e total payload and o verall numb er of cycles. I With thi s operation, all the m istaken data inside th e payload m eter are cleared. A part fro m the calibration data, all the d ata recorded in the Steps 1 to 6 (these da ta are all in accurate data ) are also deleted.

f this o peration is carried ou t in the wrong order, t he cycle da ta (beginning only) will be defective 10. After th e above operation is completed, the paylo ad meter wi ll function normally NOTI CE Re place t he battery within 48 hou Th e servi ce life of the battery is a