Komatsu — OPERATION WHEN ERROR CODE F.CAL IS DISPLAYED OR CONTROLLER HAS BEEN REPLACED

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) 6 - 63 OPERATION WHEN ERROR CODE F.CAL IS DISPLAYED OR CONTROLLER HAS BEEN REPLACED f F.CAL is disp layed, mistaken data have probably bee n written to the memory i nside the pa yload meter. n addition, whe n the controller is repl aced, old data may be r ecord ed to the new co ntroller, or t he machine condition ecognized by ondition. move the ollowing opera arry out 1. Turn the sta rting switch to the O 2. Forcibly car ry out initialization. F or details, see "CARRYING OUT FORCED INITIALIZA TION (PAGE 6-64)". 3. Turn the sta rting switch to the O N position. (F.CAL ma y flas 4.

Using the o perator check mode, set the machin e ID , open ID , speed li mit, op tion code, d ate and time. 5. Without turn ing the starting switc h to the OFF p osition, start t he engin e. (F.C AL may fla 6. Carry out c 7. Load to nea r the rated payload, t hen dump the l oad. 8. Move the m achine to a safe place , wait for at lea st 5 s ec. after dumping the loa d in Step 7, then sto p the engine. 9. Turn the sta rting switch to the O N position agai Do not start the engine when doi 10. Carry out th e DATA ALL CLEAR in the operator check mode 11. Forcibly cle ar the data for the tot al payload and overall numb er of cycles.

With this op eration, all the mistak en data inside t he p ayload m eter are c leared . Apart from the calibration data, all the data recorded in the Steps 3 to 8 (these data are all in accurate data) a re also dele ted. efective. If t his opera tion is carried out in t he wrong order , the cycle da ta (beginning on ly) will be d efective. 12. After the ab ove operation is com pleted, the payload meter wi ll function norm