Komatsu — CONTROL LEVERS AND PEDALS

. OPERATION EXPLANATION OF COMPONENTS When operating the gear shift lever, set it securely to the desired position. If it is not securely in position, the shift position display on the panel may go out and the transmission system caution lamp may light up. Before shifting between forward and reverse, stop the machine completely and then run the engine at low idle. When starting the engine, if the gear shift lever is not at the N (neutral) position, the engine will not start.

When the starting switch is turned from the OFF position to the ON position, if the gear shift lever is not at the N (neutral) position, the shift lever position pilot lamp flashes, the central warning lamp lights up, and the alarm buzzer sounds. When this happens, if the gear shift lever is returned to the N (neutral) position, the lamps will go out and the buzzer will stop. When the parking brake is applied, if the gear shift lever is not at the N (Neutral) position, the central warning lamp will light up and the alarm buzzer will sound.

If the gear shift lever is set to any position other than N (neutral) when the dump lever is at a position other than FLOAT or the body is still raised, the central warning lamp will light up and the alarm buzzer will sound. The gear shift lever must not be returned to the N (neutral) position while traveling. Before operating the gear shift lever from N to F or R, release the accelerator pedal to reduce the engine speed to low idling. When moving the shift lever from the N (neutral) position to the R (reverse) position or from the D positions to position 6, press the lock button on the shift lever before moving it.

3 - 41 6 - L p osition These positions are u sed in places where it is difficult to travel at high speed, or wh en travel ing on soft groun d, or when startin g the machin e off on a slope when it is loaded. They a re also used whe n going d ownhill if i t is needed to use the brakin g force o f the engine. While the dump body is r aised , the transmission is fixed to the 1s t gear and is not c hanged. Keep the dump b ody lowered during tr avel The speed ranges for each position are as f ollows. Position Speed range Max.

speed [km/h (MPH)] 6 1st torque converter - 6th direct 52.4 (32.6) 5 1st torque converter - 5th direct 38.5 (23.9) 4 1st torque converter - 4th direct 28.7 (17.8) 3 1st torque converter - 3rd direct 21.3 (13.2) 2 1st torque converter - 2nd direct 15.8 (9.8) L 1st torque converter - 1st direct 10.3 (6.4)