__________ BR_AK_E ~41 • Install the stopper pin into the holes@ on the caliper body and stationary cover, then tighten the bolts (stationary cover). Bolt (stationary cover): 9 Nm (0.9 m • kg, 6.5 ft • Ib) • Lubricate the one way locks 1 ® and 2 CVwith a lithium grease. • Lubricate the adjusting screw ® and back up plate ® with a silicone grease. • Insert the back up plate ® into the lever shaft hole ® . • Screw in the adjusting screw ® , and when it contacts lightly with the end of the back up plate, then back out the adjusting screw ® 1/2 to CD turn.
• Fit the end of the adjusting rachet @ into the adjusting screw @ , and align the cut in the guide (j]) with the projection of the stationary cover @ , then install the guide (j]), which is fitted to the end cover @ twisting the end cover clockwise approximately 30 degrees and tighten the screws (end cover) (j]) . Screw (end cover): 2 Nm (0.2 m • kg, 1.4 ft· Ib) • Brake pads NOTE: ______________________ _ 2. Install: When installing the brake pad at the caliper body side, make sure that projection ® on the brake pad are meshed with slot @ on the caliper body. 4-27 http://ReadManuals.com