INSPECTION AND REPAIR 1 ENG 1"-1 6. Adjust: • Oil pump stroke Adjustment steps: • Remove the locknut (1), spring washer ®and adjusting plate ® . • Adjust the pump stroke by adding or remov- ing a shim(s) @ . Adding shim Pump stroke is increased. Removing shim Pump stroke is decreased. • Reinstall the adjusting plate, spring washer and locknut. ® Locknut (adjusting plate): 7 Nm (0.7 m· kg, 5.1 ft· Ib) • Recheck the minimum and maximum pump stroke. If out of specification limits, perform the above steps again. 7.Apply: • Lithium soap base grease (to outside of pump pulley) • Yamaha Bond No.5® (ACC-11001-31-00) (to mating surface of oil pump cover) 8. Install:
• Oil pump cover (1) Screw (oil pump cover): 3 Nm (0.3 m • kg, 2.2 ft • Ib) 5-14 http://ReadManuals.com