ELECTRICAL STARTING SYSTEM I ELECI iii I 8. Measure: • Brush spring pressure Fatigue/Out of specification --+- Replace as a set. Brush spring pressure: 800 ± 150 g (28.22 ± 5.30 az) Assembly Reverse the "Disassembly" procedure. Note the following points. 1. Before installing the front and rear covers, apply bearing grease to the bearings of the front and rear covers. 2. Make sure the rear cover and front cover are fitted with O-rings. 3. Before installing the pinion gear, apply grease to the worm gear portion ofthe arma- ture shaft. Јr 4. Install: • Pinion gear CD • Return spring ® • Pinion stopper ® 5. Open the end of the new clip @ about 9 - 10 mm (0.35 - 0.40 in).
9-10mm (0.35 -0.40 in) 4 Always use a new clip. 6.lnstall the clip CD to the groove of the armature shaft ® , and press fit the clip CD to the groove with pliers ® . 8-13 http://ReadManuals.com