COOLING SYSTEM ~ --------------------------------------------------------- I IANOSJP I to) I • Hard water or salt water is harmful to the engine parts; use boiled or distilled water. • Do not use water containing impurities or oil. 14. Bleed air from the cooling system. 15. Inspect: • Cooling system Decrease of pressure (Ieaks)-)-Repair as re- quired. (see page 6-4) Inspection steps: • Attach the Cooling System Tester CD (90890- 01325, YU-22460-01) to the coolant filler ®. Apply 100 kPa (1.0 kg/cm 2 , 14 psi). • Measure the pressure with gauge. 2E071 Air bleeding 1. Bleed air from the cooling system. Air bleeding steps: • Lift up the tail ofthe machine.
• Connect plastic tubes CD tightly to the bleed screws ® on the heat exchanger. • Loosen the bleed screws ® of Heat ex- changer. • Keep the coolant running out until air bubbles disappear, while adding coolant slowly to the radiator. • Tighten the bleed screws. ~ Bleed screw: ~ 6 Nm (0.6 m • kg, 4.3 ft Ib) • Add coolant to fill the specified level ® . • Loosen the bleed bolt @ on the water pump housing. • Keep the coolant running out until air bubbles disappear. • Tighten the bleed bolt. Bleed bolt: 6 Nm (0.6 m • kg, 4.3 ft Ib) 2-9 http://ReadManuals.com