I IANOSJP I to) I COOLING SYSTEM ~ --------------------------------------------------------- • Install the radiator cap. Apply and lock the parking brake. Start the engine and run it at approximately 2500 - 3000 rpm until the thermostat opens and the coolant circulates (approximately 3 - 5 min- utes). The rear heat exchanger will be warm to the touch. A WARNING To avoid severe injury or death: Make surethe machine is securely supported with a suitable stand. • Do not exceed 3000 rpm. The machine could unexpectedly move forward if the clutch engages, or drive line damage and excessive V-belt wear could occur. • Operate the engine only in a well-ventilated area.
• Remove the radiator cap and bleed air on the cooling system again, as shown in the steps above. No air bubbles -> OK. Add coolant up to the specified level. • Pour coolant into the reservoir tank until the coolant level reaches "FULL" level mark @. 2E081 Water Pump Belt Deflection Adjustment 1. Remove: Muffler 2. Check: • Drive belt deflection Out of specification->Adjust. Drive belt deflection 8 mm (0.31 in)1 8 kg (17.6 Ib) (NEW BELT) 8 mm (0.31 in)1 13 - 20 kg (28.7 - 44.1 Ib) 3. Adjust: • Drive belt deflection Adjustment steps: • Remove the recoil stater CD. • Attach the Primary Sheave Holder (90890- 01701, YS-01880)to hold the primarysheave. 2-10 http://ReadManuals.com