CARBURETOR SYNCHRONIZATION I'~g! 1-.1 (FOR EX570SX) CARBURETOR SYNCHRONIZATION 1. Remove: • Carburetor assembly (See page 7-2, 7-11) 2. Adjust: • Carburetor synchronization Adjustment steps: • First adjust the throttle valve height ® at the No.2 carburetor by truning the throttle stop screwG) until the specified height isobtained. ~ Throttle valve height: v A 1.7 mm (0.067 in) • Second adjust the throttle valve height@on the No.1 ® carburetor with adjusting eccen- tric nut@. Move the throttle lever 2 - 3 times. • Make sure all the carburetor throttle valves are on the same height. • Install the carburetor.
Remove the rubber caps G) from the carburetor vacuum fitting and connect the Vacuum Gauge Hose (YU-08030) to the fit- tings. • Start the engine and let it warm up. If vacuum reading are not same, turn the adjusting eccentric nut@inoroutsothatthe vacuum reading are the same. NOTE: __________ _ When read the vacuum gauge, make sure carburetor covers ® are installed. 2-12 http://ReadManuals.com