CARBURETOR TUNING II:g! I «fl.1 2E321 Troubleshooting Trouble Check point Insufficient fuel Remedy Adjustment Hard starting Add gasoline Clean spark plug Return starter (choke) level to its seated position. Excessive use of starter (Excessively opened choke) Fuel passage is clogged or frozen Clean Parts otherthan air carburetor. • Clogged fuel tank air vent, clogged fuel filter, or clogged fuel passage Carburetor • Clogged orfrozen air ve nt, or clogged valve. If water collects in float chamber, clean. (Also check for ice) Overflow Improper idling speed adjustment • Pilot screw Correct Bottom the pilot screw lightly, and back it outto specification.
Adjust idling speed Start the engine and turn pilot screw in and out 1/4 turn each time. When the engine runs faster, back out throttle stop screw so the engine idles at specified speed. Tightened too much - Engine speed is higher. Adjust Backed out too much - Engine does not idle. Poor idling (Related troubles) Poor performance at low speeds • Poor acceleration Slow response to throttle • Engine tends to stall • Throttle stop screw Damaged pilot screw Replace pilot screw Clean Clogged bypass hole Clogged or loose pilot jet Clean and retighten Remove pilot jet, and blow it out with compressed air.
Air leaking into carbure- tor joint Retighten bend screw Defective starter valve seat Overflow Clean or replace Correct Poor performance at mid-range speeds (Related troubles) Momentary slow response to throttle • Poor acceleration Poor performance at normal speeds (Related troubles) Excess fuel con- sumption • Poor acceleration Clogged or loose pilot jet Clean and retighten Remove pilot jet, and blow it out with compressed air. Lean mixtures Clogged air vent Overhaul carburetor Clean Remove the air vent pipe, and clean. Clogged or loose main jet Overflow Clean and retighten Remove main jet, and blow it out with compressed air.
Check float and float valve and clean 2-35 http://ReadManuals.com