________________________________ S_T_EE_R_I_N __ G ICHASI~ I 2.Apply Low temperature lithium soap base grease (to bearing inner surface) 3. Tighten: Bearing holder nut: 22 Nm (2.2 m· kg, 16 ft· Ib) Bearing holder bolt: 27 Nm (2.7 m • kg, 20 ft· Ib) Relay rod nut: 43 Nm (4.3 m • kg, 31 ft • Ib) Always use a new lock washer and cotter pin. NOTE: ________________________ _ Bend the lock washer top along the bolts and nuts flats. 4. Adjust: • Skis Adjustment steps: Temporarily install the handlebar. • Hold the handlebar straight, and check to see that the skis are at right angles to the handle- o bar. • Loosen the locknuts (steering relay rod) G).
• Direct the skis in parallel to the moving direc- tion. With the skis thus, turn the relay rod ® either way to adjust the handlebars at right angles with respect to the direction of movement. Turning the relay The handlebars move rod in direction @ in direction © Turning the relay The handlebars move rod in direction @ in direction @ • Tighten the locknuts (steering relay rod) G). )p~ Locknut (steering relay rod): 25 Nm (2.5 m • kg, 18 ft· Ib) LOCTITE® 3-6 http://ReadManuals.com