EXHAUST SYSTEM/DRIVE V-BELT I r8f I Q.I 4. Adjust: • Starter cable free play Adjustment steps: • Loosen the locknut CD. • Turn the adjuster ® in or out until the speci- fied free play is obtained. Turning in Free play is increased. Turning out Free play is decreased. • Tighten the locknut and push in the adjuster cover. NOTE: ______________________ __ Make sure that the cable free play on both cables is equal. EXHAUST SYSTEM 1. Inspect: • Exhaust pipe gasket (s) CD Damage~Replace. Exhaust gas leakage~Repair. 2. Tighten: Exhaust pipe bolt:
23 Nm (2.3 mokg, 17 ftolb) POWER TRAIN DRIVE V-BELT Be sure there is a 2.0 mm (0.08 in) gap CD between secondary fixed and sliding sheaves when installing the NEW belt. Ifthere is no gap, the clutch engagement speed will be reduced. The machine may move unexpectedly when the engine is started . • The spacer of the secondary sheave should be adjusted. (See page 4-12) AWARNING To ensure proper clutch performance, the spacers in the secondary clutch must be repositioned as the V-belt wears. 2-15 http://ReadManuals.com