Yamaha Exciter II-570 — Primary Sheave and Drive V-Belt

PRIMARY SHEAVE AND DRIVE V-BELT IP~'trRIO 01 • Primary sheave spring CD • Primary sheave cap ® NOTE: ______________________ __ 6. Lubricate: Be sure the sheave cap match mark "X" is aligned with the spider match mark "X", Be sure to use the flange bolts @ to position ® to maintain the balance of primary sheave. 7. Tighten: Primary sheave cap bolt: 14 Nm (1.4 m • kg, 10 ft· Ib) INSTALLATION Reverse the "REMOVAL" procedure. Note the following points. 1. Install: • Primary sheave assembly Be sure to remove any oil and/or grease from the tapered portion of the crankshaft and spider using a cloth dampened with thinner. 2.Apply:

• YAMALUBE 2-cycle oil/equivalent grease (to threads of primary sheave bolt) 3. Tighten: • Bolt CD (primary sheave) Tightening steps: • Hold the primary sheave@ using the Primary Sheave Holder(90890-01701 ,YS-01880)®and tighten the bolt (primarysheave)to specifica- tion. ~ Bolt (primary sheave): (initial tightening) 120 Nm (12 m • kg, 87 ft • Ib) • Loosen the bolt (primary sheave) completely. • Retighten the bolt (primary sheave) to speci- fication. ~ Bolt (primary sheave): 60 Nm (6.0 m • kg, 43 ft • Ib) 4-7 http://ReadManuals.com