______________ B_~_K_Er~~- Insertthe backup plate @intothelevershaft hole @). • Screw in the adjusting screw@, and when it contacts lightly with the end of the back up plate, then back out the adjusting screw @ 1/2 to CD turn. 4 ; • Fit the end of the adjusting rachet ® into the adjusting screw @, and align the cut in the guide @ with the projection ofthe stationary cover @, then install the guide @, which is fitted to the end cover@ twisting the end cover clockwise approximately 30 degrees and tighten the screws (end cover) @. ~ Screw (end cover): ~ 2 Nm (0.2 m • kg, 1.4 ft Ib) 2. Install: • Brake pads NOTE:
______________________ __ When installing the brake pad at the caliper body side, make sure that projection @ on the brake pad are meshed with slot @ on the caliper body. 3. Tighten: ~ Cable holder bolt: ~ 9 Nm (0.9 m • kg, 6.5 ft Ib) 4. Adjust: • Brake cable distance (see page 2-19) 4-24 http://ReadManuals.com