Yamaha Exciter II-570 — Disassembly

DISASSEMBLY I ENG I " NOTE: ______________________ __ • Before removing the piston pin clip, cover the crankcase with a clean rag so you will not acci- dentally drop the clip into the crankcase. • Before removing the piston pin, deburr the clip groove and pin hole area. If the piston pin groove is deburred and the piston pin is still difficult to remove, use Piston Pin Puller (90890- 01304, YU-01304). • Put identification marks on each piston head for reference during reinstallation. Do not use a hammer to drive the piston pin out. CRANKCASE AND CRANKSHAFT 1. Remove: • Engine brackets CD • Crankcase (lower) NOTE:

________________________ _ • Removethe bolts starting with the highest num- bered one. • Loosen each bolt 1/4 turn, and remove them after all bolts are loosened. Ifthe case halves are tightly stuck together, tap lightly on the tabs indicated on the crankcase with a soft-head hammer. • The slits shown in the crankcase can be used to remove it. Be sure not to give damages the mating surface. 2. Remove: • Dowel pins CD • Crankshaft ® 5-5 http://ReadManuals.com