INSPECTION AND REPAIR I ENG I " • Score marks and lacquer deposits (from piston wall) Use 600 - 800 grit wet sandpaper. NOTE: ______________________ __ 4. Eliminate: Sand in a crisscross pattern. Do not sand excessively. 307-002 5. Measure: • Piston-to-cylinder clearance Measurement steps: First step: • Measure the cylinder bore "C" with a cylin- der bore gauge CD. NOTE: Measure the cylinder bore "c" in parallel to and at right angles to the crankshaft. Then find the average of the measurements.
~ Standard Wear limit Cylinder bore 73.00 ~ 73.02 mm 73.10 mm lIe" (2.874 ~ 2.875 in) (2.878 in) Taper liT" 0.05mm - (0.0019 in) Out of round 0.01 mm - "R" (0.0004 in) C = Maximum 0 T = (Maximum 01 or 02) - (Maximum 05 or 06) R = (Maximum 01, 03 or 05) - (Minimum 02, 04 or 06) • If out of specification, replace cylinder, and replace piston and piston rings as a set. 2nd step: • Measure the piston skirt diameter "P" with a micrometer. a 10 mm (0.4 in) from the piston bottom edge. I~ Piston size P Standard 72.93 ~ 72.95 mm (2.874 ~ 2.875 in) 307-000 5-7 http://ReadManuals.com