INSPECTION AND REPAIR I ENG I " 5. Measure: Maximum pump stroke ® Out of specification ---t Adjust. Maximum pump stroke ® : 1.62 - 1.8 mm (0.064 - 0.071 in) Measurement steps: • Pull the oil pump cable CD out of its sheath as far as it wi II go. The cable must be held in this taut position when measuring the maximum pump stroke. NOTE: ___________ _ It may be helpful to securely wrap duct tape ® around the cable where it enters the sheath. • Turn the pumpworm gear@withyourfinger, until the plungertop@isatits maximum dis- tance from the pump body@. • Using a Feeler Gauge, measurethe maximum pump stroke ® .
• If maximum pump stroke is not within the specified limits, perform the adjustment steps. 6. Adjust: • Oil pump stroke Adjustment steps: • Remove the locknut CD, spring washer ® and adjusting plate @. • Adjust the pump stroke by adding or remov- ing a shim(s) @. Adding shim Pump stroke is increased. Removing shim Pump stroke is decreased. • Reinstall the adjusting plate, spring washer and locknut. X Locknut (adjusting plate): 7 Nm (0.7 m 0 kg, 5.1 ft olb) • Recheck the minimum and maximum pump stroke. If out of specification limits, perform the above steps again. 5-12 http://ReadManuals.com