Yamaha Exciter II-570 — Inspection and Repair

INSPECTION AND REPAIR I ENG I ~ I CRANKCASE 1. Thoroughly wash the case halves in mild sol- vent. 2. Clean all the gasket mating surfaces and case mating surfaces thoroughly. 3. Inspect: • Crankcase Cracks/Damage ~ Replace. OIL PUMP STROKE ADJUSTMENT 1. Pull back the rubber cover (j) of the oil pump cable. 2. Remove: • Oil pump cover ® 3. Wipe off the grease from the plunger top. ®~ ® @ 5 4. Measure: Minimum pump stroke ® Out of specification ~ Adjust. Minimum pump stroke ® : 0.15 - 0.2 mm (0.0059 - 0.0079 in) Measurement steps: • Turn the pumpworm gear(j) with yourfinger, until the plunger top ® is at its maximum dis- tance from the pump body mating surface @ of the pump cover.

• Using a Feeler Gauge, measure the minimum pump stroke ® between the adjusting plate @ and the raised boss ® on the adjusting pulley. If minimum pump stroke is not within the specified limits, perform the adjustment steps. 5-11 http://ReadManuals.com