_______ E_N_G_I_N_E_A_s_s_E_M_B_~_A_N_D_A_D_J_U_S_T_M_E_N_TIENGI~I 5E032 1. Install: • Stopper ring CD (onto lower crankcase bearing ® (primary sheave side) as shown) @ Knock pin [A] Lower case [ID Upper case 2. Install: • Crankshaft assembly (to upper crankcase) NOTE: _____________________ __ Set the knock pins CD on the upper crankcase and labyrinth seal into the pin holes ® of the bearings and upper crankcase by turning the bearings and labyrinth seal. At the same time, align the bearing punched marks @ with the crankcase mating surface @. The oil seal lip must fit into the crankcase groove. 3.Apply: • Yamabond No. 5® (to mating surfaces of both case halves) 4. Install:
• Dowel pins CD • Lower crankcase CD (onto the upper crankcase ®) NOTE: ______________________ __ 5. Install: Tap lightly on the case with a soft-head hammer. 5-15 http://ReadManuals.com