Yamaha Exciter II-570 — Engine Assembly and Adjustment

_______ E_N_G_I_N_E_A_S_S_E_M_B_~_A_N_D_A_D_J_U_S_T_M_E_N_TIENGI~I WATER PUMP 1. Install: • Impeller shaft assembly (see page 6-6) • Water pump drive belt • Starter pulley • Water pump housing • Impeller • Water pump cover • Coolant hose OIL PUMP 1. Install: • Gasket • Collar Worm gear shaft • Washer • Oil pump ~ Bolt (oil pump): ~ 10 Nm (1.0 m 0 kg, 7.2 ft olb) REMOUNTING ENGINE Reverse the "ENGINE REMOVAL" procedure. Note the following points. 1. Install: • Engine assembly • Nuts G) (engine bracket) NOTE: ______________________ __ • Install the starter motor bolt® and ground lead ® before installing the engine assembly .

• Before tightening the nut (engine bracket-rear), the sheave distance should be adjusted. ~ Nut (engine bracket-front): ~ 40 Nm (4.0 m 0 kg, 29 ft 0 Ib) 2. Tighten Starter motor bolt: 23 Nm (2.3 m 0 kg, 17 ft 0 Ib) 3.Fill: • Cooling system (see page 2-7) 4. Air bleed: • Oil pump (see page 2-4) • Cooling system (see page 2-9) 5. Adjust: • Sheave distance (see page 4-12) • Throttle cable (see page 2-14) • Oil pump cable (see page 2-5) • Starter cable (see page 2-16) 5-21 http://ReadManuals.com