_________________________ C_O_O_L_IN_G __ SV_S_T_E __ M ICOOLI~I INSPECTION 1. Inspect: • Thermostatic valve Valve does not open at 50.0 - 55.0°C (122 - 131°F) -+ Replace. Inspection steps: • Suspend thermostatic valve CD in a vessel ®. • Place reliable thermometer in a water@. • Heat water slowly. • Observe thermometer @, while stirring wa- ter continually. NOTE: ______________________ __ Thermostatic valve is sealed and its setting is preset. If its accuracy is in dou bt, always replace it. A faulty unit could cause serious overheating or overcooling. 2. Inspect: • Impeller CD Cracks/Damage -+ Replace. • Mechanical seat ® • Water pump drive belt @ Wear/Damage -+ Replace. 3. Inspect:
• Bearing Pitting/Damage -+ Replace. Replacement steps: • Remove the circlip CD. • Remove the bearing using a general bearing puller. • Install the new bearing. NOTE: ____________________ __ Use a socket ® that matches the outside diameter of the race of the bearing. Do not strike the inner race of balls of the bearing. Contact should be made only with the outer race. 6-5 http://ReadManuals.com