Yamaha Exciter II-570 — Cooling Line

_________________________ C_O_O_Ll_NG __ S_VS_T_E_M_lcOOL ~1 4. Inspect: • Coolant hoses G) • Heat exchangers ev Crack/Damage ---+ Repace. 5. Measure: • Filler cap opening pressure Cap opens at pressure below the specified pressure ---+ Replace. Cap opening pressure: 80 .. 100 kPa (0.8 .. 1.0 kg/cm 2 , 11 .. 14 psi) Measurement steps: • Attach the Cooling System Tester G) (90890- 01325, YU-22460-0 1) to the coolant filler cap ev . Apply the specified pressure for 10 seconds, and make sure there is no pressure drop. INSTALLATION Reverse the "REMOVAL" procedure. Note the following points. 1. Tighten: Fuel tank nut: Water pump housing bolt:

10 Nm (1.0 m 0 kg, 7.2 ft olb) 23 Nm (2.3 m 0 kg, 17 ft 0 Ib) Impeller: 14 Nm (1.4 m 0 kg, 10 ft 0 Ib) Thermostatic valve cover bolt: 7 Nm (0.7 m 0 kg, 5.1 ft 0 Ib) 2. Adjust: • Water pump drive belt deflection (see page 2-10) 3.Fill: • Cooling system (see page 2-7) 6-6 http://ReadManuals.com