Yamaha Exciter II-570 — Chapter 7 Carburetion

_____________ C_A_R_BU_R_E_ro_R_lcA~I~1 5. Inspect: • Throttle valve CD Wear/Damage ---+ Replace. 6. Check: • Throttle valve movement Stick ---+ Replace carburetor body assembly. ASSEMBLY Reverse the "DISASSEMBLY" procedure. Note the following points. NOTE: ______________________ __ • Before reassembling, wash all parts in clean gasoline . • Always use a new gasket and a-ring. 1. Tighten: • Inner parts 0.7 Nm (0.07 m· kg, 0.51 ft· Ib) Screw (valve seat): 1 Nm (0.1 m· kg, 0.7 ft· Ib) Pilot jet: Pilot air jet/main air jet: 0.7 Nm (0.07 m • kg, 0.51 ft· Ib) Main jet: 0.8 Nm (0.08 m • kg, 0.58 ft • Ib) Starter plunger assembly: 2.5 Nm (0.25 m • kg, 1.8 ft· Ib) 2. Measure:

• Float height @ Out of specification ---+ Adjust. Float height: 21.3 ... 23.3 mm (0.84 ... 0.92 in) Measurement and adjustment steps: • Hold the carburetor in an upside down posi- tion. • Measure the distance between the carburetor body and top of the floats. NOTE: ______________________ _ The float arm should be resting on the valve, but not compressing the needle valve. 7-6 http://ReadManuals.com