Yamaha Exciter II-570 — Chapter 7 Carburetion

_____________ C_A_R_BU_R_E_ro_R_ ~~I~1 If the float height is not within specification, inspect the valve seat and needle valve. If either is worn, replace them both. If both are fine, adjust the float height by bending the float arm tang G) on the float. • Recheck the float height. 3. Lubricate: • Rubber seals • Bearings • Washer • Return spring --.. Low-temperature lithium soap base grease 4. Install: • Return springs G) NOTE: ________________________ _ Hook the spring hooks ® to the projections on the connecting lever@and carburetor body@,while twisting the spring clockwise approximately 315 degrees. • Carburetors (No.1, No.4) 5. Install:

• Connecting plate G) (lower) • Connecting plate ® (upper) Screw (connecting plates): 3.5 Nm (0.35 m • kg, 2.5 ft Ib) NOTE: Plate the carburetors on a surface plate with the intake manifold side down, Install the connecting plates while pushing the respective carburetors down with an even force. 7-7 http://ReadManuals.com