_____________ C_A_R_BU_R_E_ro_R_ cAMI~1 ASSEMBLY Reverse the "DISASSEMBLY" procedure. Note the following points. NOTE: ______________________ __ • Before reassembling, wash all parts in clean gasoline . • Always use a new gasket and a-ring. 1. Tighten: Valve seat assembly: 5 Nm (0.5 m • kg, 3.6 ft Ib) Pilot jet: 1 Nm (0.1 m· kg, 0.7 ft· Ib) Main jet: 2 Nm (0.2 m • kg, 1.4 ft· Ib) 2. Measure: • Float height ® Out of specification ---t Adjust. Float height: 17.1 .. 19.1 mm (0.67 .. 0.75 in) Measurement and adjustment steps: • Hold the carburetor in an upside down posi- tion. • Measure the distance from the carburetor body to the float arm using a gauge. NOTE:
______________________ _ • Before measurement, remove the gasket be- tween the carburetor body and float cham- ber. • The float arm should be resting on the valve, but not compressing the needle valve. Ifthe float arm height is not within specifica- tion, inspect the valve seat and needle valve. • If either is worn, replace them both. • If both are fine, adjust the float arm height by bending the float arm tang CD on the float. • Recheck the float arm height. 7-13 http://ReadManuals.com