Yamaha Exciter II-570 — Chapter 7 Carburetion

_____________ C_A_R_BU_R_E_ro_R_ cA~I~1 INSTALLATION Reverse the "REMOVAL" procedure. Note the following points. 1. Tighten: Jet needle holder screw: 2 Nm (0.2 m • kg, 1.4 ft· Ib) Starter plunger: 4 Nm (0.4 m • kg, 2.9 ft Ib) 2. Adjust: • Engine idle speed (see page 2-13) • Throttle cable free play (see page 2-14) • Starter cable free play (see page 2-16) 3. Adjust: • Carburetor switch (T.O.R.S.) Adjustment steps: Be sure engine idle speed has been adjusted to specification. Shut off the engine. • Disconnect the switch connectors. Connect the Pocket Tester (90890-03112, YU-03112) leads to the switch leads. • Loosen the lead wires ill from the holder by opening the clamp.

• Loosen the locknut ® and turn the T.O.R.S. switch @ counterclockwise until the switch is in the OFF pOSition (circuit open). • Turn the T.O.R.S. switch @clockwise until the T.O.R.S. switch is in the ON position (circuit closed). Then turn the T.O.R.S. switch clock- wise 1/2 turn and tighten the locknut ®. ~ Locknut: ~ 9 Nm (0.9 m • kg, 6.5 ft Ib) • Clamp the lead wires to the holder and con- nect the connector. • Repeat for the other carburetor switch. FUEL LEVEL ADJUSTMENT 1. Measure: • Fuel level Out of specification -t Adjust. Fuel level: 1.0 ... 3.0 mm (0.04 ... 0.12 in) 7-14 http://ReadManuals.com