Yamaha Exciter II-570 — Electrical Starting System

ELECTRICAL STARTING SYSTEM ------------------------------------------------- IELECI iii I 5. Measure: • Brush length ® Out of specification ~ Replace. Brush length limit ® : 8.5 mm (0.33 in) 6. Measure: • Brush spring pressure Fatigue/Out of specification ~ Replace as a set. Brush spring pressure: 800 ± 150 g (28.22 ± 5.30 oz) Assembly Reverse the "Disassembly" procedure. Note the following points. 1. Before installing the front and rear covers, apply bearing grease to the bearings of the front and rear covers. 2. Make sure the rear cover and front cover are fitted with O-rings. 3. When installing the rear cover assembly, take care not to scratch the brushes. 4. Install:

• Securing bolts (starter motor) NOTE: ______________________ __ Align the match marks ill on the bracket with the match marks ® on the yoke. Installation Reverse the "Removal" procedure. Note the following points. 1. Install: • Starter motor Bolt (starter motor): 21 Nm (2.1 m· kg, 15 ft· Ib) 8-11 http://ReadManuals.com