CARBURETOR TUNING I ~gr I tll TUNING CARBURETOR TUNING The carburetor is set at the factory to run at temperatures of O°C - -20°C (32°F - -4°F) at sea level. If the machine has to be operated under conditions other tha n specified above, the carburetor must be reset as required. Special care should be taken in carburetor setting so that the piston will not be damaged or seized. In this model, the engine oil is mixed with the fuel just before the fuel enters the carburetors. During initial fuel flow to the carburetor it is not always possible to supply the optimum fuel/oil mixture depending on the throttle opening.
Therefore, after the carburetors have been tuned or maintained, or after the float chamber is removed for cleaning or jet replacement, be sure to idle the engine for about . three minutes in order to avoid engine trouble. Before performing the carburetor tuning, make sure that the following items are set to specificatio n. • Engine Idle speed adjustment Throttle cable free play adjustment • Carburetor synchronization Starter cable adjustment • Oil pump cable free play adjustment Carburetor Tuning Data 1. Standard specifications Model VM38X2 Manufacturer MIKUNI 1.0.
Mark (L) 88R-OOL (R) 88R-00R Main jet (M.J.) #310 Pilot jet (P.J.) #42.5 Jet needle 6FL 82·3 (J.N.) Pilot screw 5/8 turns out (P.S.) Float height 17.1 ... 19.1 mm (0.67 ... 0.75 in) Idle speed 1,400 ... 1,600 r/min 2-31 http://ReadManuals.com