CARBURETOR TUNING I r8f I Q I Low Speed Tuning The carburetor is built so that low speed tuning can be done by adjusting the air screw CD and throttle stop screw ® . The engine should never be run without the air intake silencer and air chamber installed; severe engine damage may result. 1. Tighten the air screw CD lightly, and back it out from its lightly seated position. Standard tuning out: 5/8 2. Start the engine, and allow it to warm up for a few minutes. The warm-up is complete when the engine responds normally to the throttle opening. AWARNING Do not move the throttle enough to reach the following engagement speed. The snowmobile could accidentally start to move forward.
Engine revolutions: 3,000 rlmin 3. Adjust the throttle stop screws evenly until the engine speed is at 2,000 - 2,500 r/min. 4. Slowly loosen the pilot screws evenly. As the pilot screw is loosened, the mixture will be- come leaner, and engine speed will increase. Adjust the pilot screws to attain the highest possible engine speed. 2-35 http://ReadManuals.com