I IANOSJP I Ml·1 CARBURETOR TUNING ~ --------------------------------------------------------- 5. Finally, setthe engine idle speed by tuning the throttle stop screws in (to increase engine speed) or out (to decrease engine speed). Standard idle speed: 1,400 .. 1,600 r/min 6.lf the engine low speed performance is still poor in high elevation under extreme condi- tions, the standard pilot jets may need to be replaced to obtain proper pilot air/fuel mix- ture. NOTE: ______________________ __ In this case, set the carburetor on the richer side; use a larger number pilot jet. Standard pilot jet: #42.5 7. By repeating steps 1 to 5 above, adjust the idle speed.
Middle-Range and High Speed Tuning No adjustment is normally required, but adjust- ment is sometimes necessary depending on temperatures and/or altitude. Middle-range speed and high speed tuning (from 1/4 to full-throttle) can be done by adjusting the main jet. The engine should never be run without the air intake silencer and air chamber installed; severe engine damage may result. 2-36 http://ReadManuals.com