Yamaha Exciter II-570 — Steering

________________ S_T_E_E_R_IN_G~~IJI 4. Apply Low temperature lithium soap base grease (to bearing inner surface) 5. Tighten: Bearing holder nut: 22 Nm (2.2 m • kg, 16 ft· Ib) Bearing holder bolt: 27 Nm (2.7 m • kg, 20 ft· Ib) Relay rod nut: 43 Nm (4.3 m • kg, 31 ft • Ib) Always use a new lock washer and cotter pin. NOTE: ___________ ___ Bend the lockwashertop along the bolts and nuts flats. 6. Adjust: • skis Adjustment steps: • Temporarily install the handlebar. • Hold the handlebar straight, and check to see that the skis are at right angles to the handle- bar. • Loosen the locknuts (steering relay rod) CD . • Direct the skis in parallel to the moving direc- tion.

• With the skis thus, turn the relay rod ® either way to adjust the handlebars at right angles with respect to the direction of movement. o Turning the relay The handlebars move rod in direction ® in direction © Turning the relay The handlebars move rod in derection @ in direction @ • Tighten the locknuts (steering relay rod) CD . I® Locknut (steering relay rod): 25 Nm (2.5 m • kg, 18 ft· Ib) LOCTITE® 3-6 http://ReadManuals.com