Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Battery Removal and Installation NOTICE After securing the battery, check that it does not move. If it moves, tighten it again securely. 3 - 108 Before removing the battery, r emove the ground cable (normally connected to the n egative (-) terminal). If any tool touches between th e positive terminal and the chassis, there is a hazard of sparks being generated. When installing the battery, co nnect the ground cable last. Install the battery securely to th e determined place. When doing this, be careful not t o let the clamps conta ct the terminals. When replacing the battery, fix the new battery securely in clamp (1).

nut (2) is 4.9 to 5.9 N·m (0.5 to 0.6 p of the battery covers the battery ck. ce it immediately. lated on the top surface of the als, wash with hot water at a 4°F), then dry completely before position with battery mounting Tightening torque of mounting kgf·m, 3.6 to 4.3 lbft). Make sure that the cover on to completely. Do not let it roll ba If the cover is damaged, repla If there are chlorides accumu battery or around the termin temperature of about 40°C (10 installing the wires. Battery Charges battery is not handled correctly, may explode. Always follow the ATTERY (PAGE 3-107)" and the g the charger, and do as follows.

generated when the battery is ry from the chassis, take it to a move the battery caps before curely. If any battery cap is ly. to match the voltage of the battery to be charged. If the correct voltage is not rheat and cause an explosion. er clip of the charger to the positive (+) terminal of the battery, then connect the When charging the battery, if the there is a hazard that the battery instructions of "DISCHARGED B instruction manual accompanyin Flammable hydrogen gas is charged, so remove the batte well-ventilated place, and re charging it.

Tighten the battery caps se damaged, replace it immediate Set the voltage of the charger selected, the charger may ove Connect the positive (+) charg e battery, then conne ct the negative (-) charger clip of th securely. e charger to the negative (-) terminal of the battery. Be sure to attach the clips Set the charging current to 1/1 0 of the value of the rated battery capacity; when carr ying out rapid chargin g, set it to less than the rated battery capacity. If the charger current is too high , the electrolyte will leak or dry up, and this may cause the battery to catch fir e and explode.

If the battery electrolyte is froz en, do not charge the battery or start the engine with a different power source. ignite the battery electrolyte and cause the battery to explode. There is a danger that this will ignite the battery electrolyte and cause the battery to Do not use or charge the batte ry if the battery electrolyte level is below the LOWER L EVEL line. This may c ause an explosion. Check the batter y electrolyte level periodically and add distilled water to bring the electrolyte level to the UPPER LEVEL line.