Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Starting Engine with Booster Cables When starting the engine with a booster cable, do as follows: Connecting and Disconnecting Booster Cables WARNING booster cable, always wear safety structure frame), a spark will be spot as far away from the battery as exercise good care so that the each other, or they contact the Booster Cable Connection Keep the starting switch of the normal machine and problem machine in the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine. 2.

Connect the other clip of booster cable (A) to the positive (+) terminal of the normal machine. 3. Connect one clip of booster cable (B) to the negative (-) terminal of the normal machine. 4. Connect the other clip of booster cable (B) to the engine block of the problem machine. 3 - 109 When connecting the cables, neve (-) terminals. When starting the engine with a glasses. Be careful not to let the normal m each other. This prevents sparks f could ignite the hydrogen gas giv explodes, it could cause serious i Be careful not to make a mistake the last connection (to the upp caused, connect the cable to a s possible.

(Avoid the work equipm conductor) When removing the booster ca booster cable clips may not con chassis. NOTICE clip should be suitable for the battery size. The size of the booster cable and clip should be suitable for the battery The battery of the normal machin e must be the same capacity as that of the e ngine to be started. Check the cables and clips for da mage or corrosion. ps are firmly connected. machines are in the LOCK position. UTRAL position. Make sure that the cables and cli Check that the lock levers of both Check that each lever is in the NE