Komatsu — MAINTENANCE INFORMATION

. MAINTENANCE MAINTENANCE INFORMATION the mounting surface, and 4 - 3 Clean and replace the fuel filter frequently. pecially the starting motor and alternator, to avoid accumulation of dust. Clean electrical components, es pecially the starting motor and alternator, to avoid accumulation o f dust. When inspecting or changing the oil, move the machine to a place that is free of d ust to prevent dir t from getting into the oil. Avoid Mixing Lubricants If a different brand or grade of oil ha s to be added, drain the old oil and replace all the o il with the new b rand or grade of oil. Never mix different brand or grade of oil.

Cover on Right Side of the Machine If the cover on the right side of the machine is fully opened and the boom is swung to the right, there is dang er that the boom may hit the cover and br eak it. ight with the cover open, set the cover so that it is half-open. If the boom must be swung to the r ight with the cover open, set the cover so that it i s half-open Locking the Inspection Covers Lock inspection cover securely in to position with the lock bar. If inspection or maintenance is performed with intenance erforme inspection cover not locked in posit ion, there is a danger that it may be suddenly blo w shut by t he wi nd and cause injury to the worker.

Hydraulic System - Air Bleeding After repairing or replacing the hyd raulic equipment or after removing the hydraulic p iping, it is necessary to bleed the air from the circuit. For details, see "BLEEDING AIR FROM HYDRAULIC SYST EM (PAG E 4-4 2)". Hydraulic Hose Installation When removing parts at locatio replace with new parts. When doing this, be careful not t ns where there are O-rings or gasket seals, clea o forget to assemble the O-rings and gaskets. When installing the hoses, do no t twist or bend them into loops with a small radiu This will cause damage to the h ose and drastically reduce its service life.

Checks After Inspection and Mainte nance Works If you forget to perform the checks a fter inspection and maintenance, unexpected prob lems may occur , and th is may lead to serious injury or property d amage. Always do the following: ine stopped) ntenance points been forgotten? tenance items been performed correctly? Checks after operation (with eng Have any inspection and mai Have all inspection and main Have any tools or parts been inside the machine and get c Are there any leakage of coo dropped inside the machine? It is particularly da ngerous i f parts are dr opped aught in the lever linkage mechanism. lant or oil? Have all nuts and bolts been tightened?

en operating the engine, see "TWO WORKERS FOR MAINTENANCE WHEN E 2-35)" and pay careful attention to safety. enance items working properly? r oil when the engine speed is raised? lant or oil? Have all nuts and bolts been tightened Checks when operating engine For details of the checks wh ENGINE IS RUNNING (PAG Are the inspection and maint Is there any leakage of fuel o Use of Fuel and Lubricants Accordi ng to Ambient Temperature It is necessary to decide the type o f fuel and lubricants according to the ambient tem perature. For details, see "LUBRICANTS, F UEL AND COOLANT SPECIFICATIONS (PAGE 4-9)".