. MAINTENANCE OUTLINE OF SERVICE OUTLINE OF SERVICE HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC 4 - 4 Oil Oil is used in the engine and hydraulic eq pressure), and deteriorates with use. Always use oil that matches the grade and Operation and Maintenance Manual. Even uipment under extremely severe conditions (high temperature, high maximum and minimum ambient temperatures recommended in the if the oil is not dirty, always change the oil at the specified interval. Oil corresponds to blood in the human body , always be careful when handling it to prevent any impurities (water, metal particles, dirt, etc.) from getting in.
The majority of problems with the machine Take particular care not to let any impuritie are caused by the entry of such impurities. s get in when storing or adding oil. s. causes of problems. Never mix oils of different grades or brand Always add the specified amount of oil. Having too much oil or too little oil are both If the oil in the work equipment is not clear , there is probably water or air getting into the circuit. In such cases, please contact your Komatsu distributor. related filters at the same time. de of the oil periodically to check the condition of the machine. For contact your Komatsu distributor. ay be necessary to shorten the oil change interval.
l use of the Komatsu oil clinic. When changing the oil, always replace the We recommend you have an analysis ma those who wish to use this service, please When using commercially available oil, it m For this reason, we recommend making ful Fuel After completing the day's operations, fill th e fuel tank to force out any air containing moisture. This will prevent the moisture from condensing and mixing with the fuel. nd if fuel containing water or dirt is used, it cannot work properly. et in when storing or adding fuel. ion and Maintenance Manual.
The fuel pump is a precision instrument, a Be extremely careful not to let impurities g Always use the fuel specified in the Operat Fuel may congeal depending on the tempe °F)). It is necessary to use the fuel that is s rature when it is used (particularly in low temperature below -15°C (5 uitable for the temperature. Before starting the engine, or when 10 minu tes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from the circuit. If there is any foreign material in the fuel ta nk, wash the tank and fuel system.
Cooling System Coolant River water contains large amount of calciu m and other impurities, so if it is used, scale will stick to the engine and radiator, and this will cause defective heat Do not use water that is not suitable for dri exchange and overheating. nking. precautions given in the Operation and Maintenance Manual. When using antifreeze, always observe the Komatsu machines are supplied with Kom atsu original anti-freeze in the coolant when the machine is shipped. This anti-freeze is effective in preventing c The anti-freeze can be used continuously f hot areas. orrosion of the cooling system. or two years or 4000 hours.
Therefore, it can be used as it is even in areful not to expose it to flame or fire. s according to the ambient temperature. CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-20)". to cool before adding coolant. Antifreeze is flammable, so be extremely c The proportion of anti-freeze to water differ For details of the mixing proportions, see " If the engine overheats, wait for the engine