. MAINTENANCE OUTLINE OF SERVICE 4 - 7 ELECTRIC SYSTEM MAINTENANCE It i s extremely dange rous if the electrical equip ment becomes we t or the covering of the wirin g is damaged. This wil l cause an electric al short circuit and may l ead to malfunction of the machine . Do not wa sh the i nside o f the operator's cab with components. water. When washing the machine, be careful not to let water get into the electrical electrical Service relating to th e electric system is check ing fan belt tensio n, checking dam age or wea r to the fan bel t and checking battery flui d level. ctric components other than those specified by Komatsu.
Never install any ele ctric components other th an those specified External electro-mag netic interference may ca use malfunction o f the control sys tem controll er, before installing a r adio receiver or ot her wireless equipment, contact your Koma tsu distributor. rosion. When working at the seashore, carefully clea n the electric syste m to prevent cor When installing an o perator's cab cooler or an y other electrical equipment, conn ect it to an independent p ower source connector. T he cables to supply powe r to the optional eq uipment must n ever be con nected to the fuse, starting switch, or ba ttery relay.
HANDLING HYDRAULIC SYSTEM re during operations and immediately after operations. During Hydraulic equipmen t is at a high temperatu operations . D uring operations, it is also maintenance of hydr Stop the machine pressure on the c Always stop the e Immediately after pressure. Wait fo Even when the te screws, or hose c before removing. Always release th maintenance of th operations, it is also under high pressure, so b e careful of the fol lowing points wh en carrying out inspectio n and maintenance of hydr aulic-related equipment. Stop the machine pressure on the c Always stop the e Immediately after e hydraulic oil an mperature and high pressure.
Wait fo r the temperature to go d own before startin g the maintenan ce operatio n. Even when the te mperature goes down, the circuits may be un der internal pres sure, so wh en loosening p lugs, screws, or hose c onnections, do not stand directly in front. Lo osen gradually t o release th e internal pressure before removing. Always release th e air in the hydraulic tank to remove the inter nal pressure bef ore carrying out inspectio n and maintenance of th e hydraulic circuit. Inspection and main an d replacement of If h igh-pressurehose s have been removed, ch eck that there is no damage to the O -rings. If an y damage is fo und, replace the O-ring.
It i s necessary to ble ed the air from the circuit s when the hydrau lic filter element or strainer h ave been replaced or washed, or when hydraulic equipment has been repaired or r eplaced, or when the hydrau lic piping has been removed.